Kropelka is a super glue that is worth having in your home toolbox due to its practicality, effectiveness, and reliability.
Its use is very easy; just remember four simple steps.
Opening
To open the tube for the first time, take the nozzle in your hand and screw it all the way onto the tube's thread until the membrane is pierced.
Surface Check
The surfaces to be glued must fit together precisely. Make sure both surfaces are clean.
Application
Remove the cap from the nozzle. Squeeze the tube at the marked points to measure and dispense a single drop onto only one of the two surfaces to be glued.
Press the surfaces together
Hold both glued parts pressed together for 60 seconds. The bond is ready.
Using the product
- To open the tube with Kropelka for the first time, screw the dispenser connected to the cap onto the tube's thread until the membrane is pierced. Be careful not to squeeze the tube too hard to avoid spilling the glue.
- Applying a small amount will give you a better bond, and the glue will set faster.
- It is best not to subject the fresh bond to forces and loads for at least 1 hour.
- Remember that Kropelka does not bond polyolefins (polyethylene and polypropylene), Teflon (PTFE), EVA rubber, or silicone.
- Kropelka is ideal for bonding parts that fit well together; it does not have gap-filling properties.
- Kropelka provides the strongest bond at room temperature and withstands up to 60 C, depending on the application.
- Kropelka is not flammable.
- Kropelka does not withstand direct contact with flames.
- For large surfaces, apply drops spaced 2 cm apart, always on only one of the surfaces.
Recommendations and precautions
- If Kropelka spills during repairs, wipe it immediately with acetone. Before using acetone, first check in a less visible area to ensure the solvent does not damage the surface.
- Remember - if the Kropelka dispenser is clogged, never squeeze the tube forcefully.
- Clear the nozzle of the tube with a pin, holding the tube so that it is not directed at your body.
- To ensure that the same tube of Kropelka glue lasts as long as possible and can be used multiple times, screw it tightly and store it in a cool, dry place, preferably standing upright on its base. After use, wipe the applicator tip with a dry tissue or absorbent paper.
- If Kropelka spills on your hands, it is best to wash them with a large amount of lukewarm water; larger pieces of hardened glue can be removed with a gentle abrasive material (such as pumice) under running water. Then apply cream to your hands to soften the skin.
- If Kropelka gets into your eyes, do not close your eyelids.
- Rinse them with a large amount of lukewarm water and consult a doctor immediately.
Warnings
- Kropelka has not been approved for medical or veterinary use, so we do not recommend using it on any part of the body of humans, animals, or on dental appliances or prosthetics.
Attention!
The product should be used according to the manufacturer's instructions.
Before use, familiarize yourself with the warnings and information regarding safe use.
In case of contact with eyes, skin, or swallowing - seek medical advice immediately and show the packaging or label of the product.
Keep out of reach of children. Avoid inhaling vapors and contact with eyes.
Detailed information regarding properties, hazards, and emergency procedures can be found in the Safety Data Sheet (SDS), available for download at the link below.
Postępu 18 b
02-676 Warszawa
Polska
Email: bripox@bripox.pl
Telephone: 228682614
Postępu 18 b
02-676 Warszawa
Polska
Email: bripox@bripox.pl
Telephone: 228682614