K7DCO carbon monoxide sensor equipped with Kidde electrochemical sensor, guaranteeing a 10-year service life. Battery power allows the detector to be installed in an optimal place in the room and provides protection even in the event of a power outage in the mains.
The built-in LCD display shows the carbon monoxide concentration level between 0 and 999 PPM. CO concentration measurements are performed every second. Exceeding the permissible CO level is signaled optically (red LED) and acoustically (loud, pulsed audible alarm with a strength of 85dB). The device's memory stores information about the detection of CO concentration exceeding the level of 100 PPM.
This allows the user to make sure that no carbon monoxide emissions have occurred during their absence from the room.
The sensor has a test/reset button to check the operation of the device and reset the alarm signal, as well as a button when pressed, which displays the highest detected CO level stored in the sensor's memory. The sensor also has a function that informs you when an alarm has been activated in the last 14 days. This allows the user to make sure that no carbon monoxide emissions have occurred during their absence from the room.
The efficiency control system monitors the m.in of the sensor, internal circuitry and battery status on an ongoing basis. In the event of incorrect operation or low battery level, the yellow LED flashes, the corresponding graphic information is displayed on the LCD panel and a warning beep is activated. In addition, the sensor is equipped with a simulation test function that allows you to quickly check the correct response of the sensor to the CO test gas.
Thanks to its special shock-resistant design, the detector has been approved for use not only in houses and apartments, but also in caravans, motorhomes and boats. After 10 years from activating the power, the sensor will remind you to replace the device.
The K7DCO is marked with the construction mark B confirming compliance with the Polish standard PN-EN 50291-1:2018+AC 2021 for home carbon monoxide detectors. The tests were carried out by the Scientific and Research Centre for Fire Protection of the Józef Tuliszkowski National Research Institute (CNBOP-PIB) and has a BSI certificate confirming compliance with the requirements of the BS EN 50291-1:2018 standard issued by the British Standards Institution (BSI).
In addition, the K7DCO sensor is certified to meet the requirements of BS EN 50291-2:2019 (PN-EN 50291-2:2020) and allows the device to be used in motorhomes and boats. Compliance with the above-mentioned standard has been confirmed by an independent testing body, the British Standards Institution.
1016 Corporate Park Drive
NC 27302 Mebane
USA
Email: product.support@kiddeus.com
Telephone: 888.244.9979
Aksamitna 4
02-287 Warszawa
Polska
Email: biuro@aisko.pl
Telephone: 22 666 37 27